Our next meeting 30-09-2021 Showtime. Start time 6.45pm

Its showtime once more, and the first showtime we have arranged after the re-start of our regular meetings. The purpose of the showtime meetings is to let other members of the club see what you have been up to since the shut down, as the time closed was about 18 months you must all have plenty of things you have made over that period of time, now is the time to share them with the rest of our members. There is no limit on the amount of items you could bring to the showtime, we will assess how many each person can show once we see the number of items being shown. It would be good if during the showing of your work you could give the members a commentary on what you made.

Continue reading “Our next meeting 30-09-2021 Showtime. Start time 6.45pm”

Report on our meeting 16-09-2021 Demo by John Ruickbie.

Our meeting on Thursday 16th September 2021 was a demonstration by John Ruickbie, John was to make a bandstand clock using some slats from whisky barrel staves. John had brought along a finished example along with some of the stave material, he explained that these were not square nor were they straight and that they had also been scorched on the inside, all of this presented some problems when mounting them on the lathe, John had made up some jigs to help overcome some of these problems. John also knew the time allocated for the demonstration would not be enough for the entire project to be completed so he did some of the preparation work at home and would show and explain how it was done as he went through the procedure.

Continue reading “Report on our meeting 16-09-2021 Demo by John Ruickbie.”

Report on our meeting 02-09-2021 light assisted goblet.

This was our first meeting after the pandemic restrictions were lifted that turning was involved, and it was good to be back in operation again. We have made some changes within the club to make it much safer for everyone to return, this included installing some ventilation fans and a CO2 monitor, and to combat any dust issues, we are currently installing a full dust extraction system to all the lathes and the bandsaw.

Continue reading “Report on our meeting 02-09-2021 light assisted goblet.”